User's Manual

Appendix A Status Codes
NI-DAQ FRM for PC Compatibles A-6
© National Instruments Corporation
–10124 gpctrBadEntityIDError Invalid entityID used.
–10125 gpctrBadActionError Invalid action used.
–10200 EEPROMreadError Unable to read data from EEPROM.
–10201 EEPROMwriteError Unable to write data to EEPROM.
–10202 EEPROMWriteProtection Error You cannot write into this location or
area of your EEPROM because it is
write-protected. You may be trying to
store calibration constants into a
write-protected area; if this the case, you
should select user area of the EEPROM
instead.
–10240 noDriverError The driver interface could not locate or
open the driver.
–10241 oldDriverError One of the driver files or the
configuration utility is out of date.
–10242 functionNotFoundError The specified function is not located in
the driver.
–10243 configFileError The driver could not locate or open the
configuration file, or the format of the
configuration file is not compatible with
the currently installed driver.
–10244 deviceInitError The driver encountered a
hardware-initialization error while
attempting to configure the specified
device.
–10245 osInitError The driver encountered an
operating-system error while attempting
to perform an operation, or the
operating system does not support an
operation performed by the driver.
–10246 communicationsError The driver is unable to communicate
with the specified external device.
Table A-1.
Status Code Summary (Continued)
Status Code Status Name Description