User's Manual

Chapter 2 Function Reference — WFM_Group_Control
NI-DAQ FRM for PC Compatibles 2-422
© National Instruments Corporation
generated after NI-DAQ executes RESUME. RESUME restarts waveform generation if
NI-DAQ has completed the number of iterations specified in
WFM_Load.
operation = 5 (STEP): This operation initiates a waveform generation at the analog output
channels in the group when the trigger mode has been set up to STEPPED or BURST using
AO_Change_Parameter call. To advance to the next stage defined in the sequence list, call
WFM_Group_Control again with operation = STEP. In this way, you can step through all of
the stages defined in the sequence list.
Note This value of operation = STEP is supported for the DAQArb 5411 devices only.