User's Manual

Chapter 2 Function Reference — Init_DA_Brds
NI-DAQ FRM for PC Compatibles 2-262
© National Instruments Corporation
Of all these defaults, you can alter only the analog input and analog output settings of the
non-E Series MIO and AI devices, Lab-PC+, and PC-LPM-16 devices by setting jumpers on
the device. If you have changed the jumpers from the factory settings, you must call either
AI_Configure and/or AO_Configure after Init_DA_Brds so that the software copies of
these settings reflect the true settings of the device.
If any device resources have been reserved for SCXI use when you make a call to
Init_DA_Brds, those resources will still be reserved after you make the function call.
Refer to Chapter 12, SCXI Hardware, in the DAQ Hardware Overview Guide for listings
of the different device resources that can be reserved for SCXI.