Computer Accessories User Manual
Table Of Contents
- NI-DAQmx Base 3.x Getting Started Guide
- Contents
- Conventions
- Related Documentation
- Overview
- Operating System, Application Software, Programming Language, and Device Support in NI-DAQmx Base 3.x
- Install Application Software
- Step 1. Install the NI-DAQmx Base Software
- Step 2. For Devices Using the LabVIEW 8.5 PDA Module for Windows Mobile Only-Run the PDA Setup Utility
- Step 3. Unpack the Devices, Accessories, and Cables
- Step 4. Install the Devices, Accessories, and Cables
- Step 5. Confirm That Your Device Is Recognized
- Step 6. Create and Configure Tasks
- Documentation
- Getting Started Developing an Application
- Where to Go for Support
NI-DAQmx Base Getting Started Guide 12 ni.com
Devices Using the LabVIEW 8.5 PDA Module for
Windows Mobile
Using the NI-DAQmx Base Task Configuration Utility is required when
using devices with the LabVIEW 8.5 PDA Module for Windows Mobile.
In NI-DAQmx Base 3.0, task information is embedded in the built
application. Prior to building and downloading your VI to the PDA device,
you must configure and save the tasks you want to use.
To use the Task Configuration Utility, complete the following steps:
1. Open LabVIEW.
2. Select Tools»NI-DAQmx Base Task Configuration Utility.
Note You also can launch the Task Configuration Utility from Start»Programs»
National Instruments»NI-DAQmx Base.