Network Card User Manual

-10441
memConfigErr
No memory is configured to support the
current data-transfer mode, or the
configured memory does not support the
current data-transfer mode. (If block
transfers are in use, the memory must be
capable of performing block transfers.)
-10442
memDisabledErr
The specified memory is disabled or is
unavailable given the current addressing
mode.
-10443
memAlignmentErr
The transfer buffer is not aligned properly
for the current data-transfer mode; e.g., the
buffer is at an odd address, is not aligned to
a 32-bit boundary, is not aligned to a 512-
bit boundary, and so on. Alternatively, this
error can occur if the driver is unable to
align the buffer because the buffer is too
small.
-10444
DSPmemFullErr
Possible reasons for this error are as
follows.
• No more system memory is available
on the heap.
• No more memory is available on the
device.
• You have insufficient disk space
available.
-10445
memLockErr
The transfer buffer cannot be locked into
physical memory.
-10446
memPageErr
The transfer buffer contains a page break;
system resources may require
reprogramming when the page break is
encountered.
-10447
memPageLockErr
The operating environment is unable to
grant a page lock.
-10448
stackMemErr
The driver is unable to continue parsing a
string input due to stack limitations.
-10449
cacheMemErr
A cache-related error occurred, or caching
is not supported in the current mode.
-10450
physicalMemErr
A hardware error occurred in physical
memory, or no memory is located at the
specified address.