Network Card User Manual
AT-MIO-16/16D By Channel By Device By Device By Device DC
Note: “By device” means you select the value of a parameter with hardware jumpers, and
the selection affects any group of channels on the device. “By group” means you
program the selection through software, and the selection affects all the channels
used at the same time. “By channel” means you program the selection with hardware
jumpers or through software on a per channel basis. When a specific value for a
parameter is shown, that parameter value is fixed.
Device Number of
Channels
Resolution Gains
1
Range (V)
1
Input FIFO
(words)
Scanning
2
AT-MIO-16E-1
AT-MIO-16E-2
AT-MIO-16E-10
AT-MIO-16DE-10
NEC-MIO-16E-4
NEC-AI-16E-4
16SE, 8DI 12 bits
0.5, 1, 2,
5, 10, 20,
50, 100
±5, 0 to 10 512; E-1:
8,192; E-2 and
E4: 2,048
Up to 512
AT-MIO-64E-3 64SE, 32DI 12 bits
0.5, 1, 2,
5, 10, 20,
50, 100
±5, 0 to 10 2,048 Up to 512
NEC-MIO-16XE-50
NEC-AI-16XE-50
AT-MIO-16XE-50
DAQPad-MIO-16XE-50
PCI-MIO-16XE-50
16SE, 8DI 16 bits
1, 2,10,
100
±10, 0 to 10 512 Up to 512
AT-MIO-16F-5
AT-MIO-64F-5
16SE, 8DI
64SE, 32DI
12 bits
0.5, 1, 2,
5, 10, 20,
50, 100
±5, ±10, 0 to
10
16F-5: 256;
64F-5: 512
Up to 512
AT-MIO-16X 16SE, 8DI 16
1, 2, 5,
10, 20,
50, 100
±10, 0 to 10 512 Up to 512
AT-MIO-16(L)
AT-MIO-16(H)
AT-MIO-16D(L)
AT-MIO-16D(H)
16SE, 8DI 12 (L) 1, 10,
100, 500;
(H): 1, 2,
4, 8
±5, ±10, 0 to
10
16 (L,H);
512 (DL, DH)
Up to 16
1 You can determine the limit settings of your device by dividing the range by the desired gain.
2 Scanning = channels, in any order.