User's Manual

© National Instruments Corporation I-1 NI 5911 User Manual
Index
Numbers
+5 V signal
limitation on current (note), 1-3
self-resetting fuse (note), 1-3
A
AC coupling, 2-4
accuracy characteristics, A-2 to A-3
accurate measurements for digitizers.
See digitizers.
acquisition
multiple record, 2-13 to 2-14
VirtualBench-Scope soft front panel,
1-4to1-5
acquisition characteristics specifications,
A-2 to A-5
accuracy, A-2 to A-3
common-mode characteristics, A-3
distortion, A-4 to A-5
dynamic range, A-4
filtering, A-3
acquisition modes specifications, A-7
ADC resolution, B-4
analog bandwidth, B-2
analog trigger circuit, 2-9 to 2-11
above-level analog triggering mode
(figure), 2-10
below-level analog triggering mode
(figure), 2-10
high-hysteresis analog triggering mode
(figure), 2-11
low-hysteresis analog triggering mode
(figure), 2-11
arming. See triggering and arming.
B
bias, input, 2-4
block diagram of NI 5911, 2-1
BNC connector, 1-1 to 1-2
C
calibration
errors occurring during acquisition,
2-7to2-8
external calibration, 2-8
internal calibration, 2-7 to 2-8
specifications, A-8
clocklines,2-14to2-15
common-mode characteristics, A-3
connectors
BNC connector, 1-1
DIN connector, 1-1
location on front panel (figure), 1-2
SMB connector, 1-1
conventions used in manual, iv
customer education, C-1
D
dead time, in multiple record acquisition, 2-13
differential input
grounding considerations, 2-2
noise-free signal measurement (figure), 2-2
differential programmable gain input amplifier
(PGIA), 2-1 to 2-4
AC coupling, 2-4
differential input, 2-2
input bias, 2-4
input impedance, 2-3 to 2-4
input protection, 2-4
input ranges, 2-3