User manual

41
Figure 3.24. MSO Display With Signals Active
7. Now that you have achieved the two signals you are looking for, you need to configure measurements on the
two signals. Again, do this by selecting the icon in the MSO display that looks like a meter stick (as in Figure
3.15).
8. In the Measurements toolbar, configure a Rise Time measurement under the Time Category for both channels 1
and 2. Once you have selected these items, they should remain visible at the bottom of the MSO display until
you deselect them.
Figure 3.25. Configuring Rise Time Measurement on Both Channels
9. Make note of the 10%-90% rise times for channels 1 and 2.
a. 10%-90% Rise Time (measured) :_______________________
Are these values close to your theoretical calculations from the previous section? If you remember that the 10%-
90% rise time on the output should be approximately 2.2 ms, you should notice that the rise time of the signal
on channel 2 is close to the value of 2.2 ms that you anticipated.
10. Export the VirtualBench data to a .CSV file as shown in Figure 3.18.