User manual

 Connect the V_POS (pin 7 of op-amp) to the +25 V supply of the VirtualBench power supply (red wire on

breadboard)

 Connect the V_NEG (pin 4 of op-amp) to the -25 V supply of the VirtualBench power supply (light green wire on

breadboard)

 Connect the GND of the ±25 V supply to the ground of amplifier circuit (black wire on breadboard)

 Place R1 (1 kΩ) between V Out (pin 6 of op-amp) and pin 2 of the op-amp (teal and purple jumper wires on

breadboard)

 Place R2 (100 Ω) between junction connecting R1 to op-amp pin 2 and ground

 Connect V In (pin 3 of op-amp) to the positive output from the VirtualBench FGEN (yellow wire on breadboard);

connect negative output from FGEN to ground (black wire on breadboard)

 Connect the output from the VirtualBench FGEN to the CH1 of the VirtualBench MSO (yellow wire on

breadboard)

 Connect V Out (pin 6 of op-amp) to the positive input on CH2 of the VirtualBench MSO (blue wire on

breadboard)

 Connect the negative input on CH1 of the VirtualBench MSO to ground (dark green wire on breadboard)

 Connect the negative input on CH2 of the VirtualBench MSO to ground (dark green wire on breadboard)

Figure 3.6a. UA741CN Connection Diagram