User manual

26
Figure 3.4. Multisim Oscilloscope Capture and Results for RC Circuit
As shown in Figure 3.4, you can use horizontal cursors T1 and T2 to find the 10% and 90% levels on Channel B as
accurately as possible. Since the maximum level is 5 V, these values should be 500 mV and 4.5 V, respectively. However,
because the scope horizontal resolution is limited, you had to align the cursors as close as possible to these values at
558.929 mV and 4.490 V. Taking the time difference between these two cursors, you can see that the 10%-90% rise time
is approximately 2.121 ms. This value is very close to the estimate of 2.2 ms.