User manual

15
Figure 2.8. FGEN Configured for DC Voltage With 5.00 Vdc Offset
3. Configure the DMM to take a voltage measurement. Set your DMM measurement mode to “DC Voltage.” After
setting the measurement mode, you will need to set the resistance. From the simulation results in Table 2.1, you
know that the voltage should be around 5 V. Therefore, set the range to 10 V, which allows you to capture the
measurement without any voltage saturation.. Figure 2.9 shows the DMM with the proper mode and range
configured.
Figure 2.9. DMM Configured for DC Voltage Measurements With 10 V Range
4. Enable the FGEN output by clicking the FGEN power button shown in Figure 2.10.