Welding System User Manual

Appendix A Status Codes
© National Instruments Corporation A-17 NI-DAQ FRM for PC Compatibles
–10634 noContTransferInProgressError No continuous (double-buffered)
transfer is in progress for the specified
resource.
–10635 invalidSCXIOpModeError Either the SCXI operating mode
specified in a configuration call is
invalid, or a module is in the wrong
operating mode to execute the function
call.
–10636 noContWithSynchError You cannot start a continuous
(double-buffered) operation with a
synchronous function call.
–10637 bufferAlreadyConfigError Attempted to configure a buffer after
the buffer had already been configured.
You can configure a buffer only once.
–10680 badChanGainError All channels of this board must have the
same gain.
–10681 badChanRangeError All channels of this board must have
the same range.
–10682 badChanPolarityError All channels of this board must be the
same polarity.
–10683 badChanCouplingError All channels of this board must have
the same coupling.
–10684 badChanInputModeError All channels of this board must have
the same input mode.
–10685 clkExceedsBrdsMaxConvRateError The clock rate exceeds the board’s
recommended maximum rate.
–10686 scanListInvalidError A configuration change has invalidated
the scan list.
–10687 bufferInvalidError A configuration change has invalidated
the acquisition buffer, or an acquisition
buffer has not been configured.
Table A-1.
Status Code Summary (Continued)
Status Code Status Name Description