Welding System User Manual

Appendix A Status Codes
© National Instruments Corporation A-7 NI-DAQ FRM for PC Compatibles
–10247 cmosConfigError The CMOS configuration-memory for
the device is empty or invalid, or the
configuration specified does not agree
with the current configuration of the
device, or the EISA system
configuration is invalid.
–10248 dupAddressError The base addresses for two or more
devices are the same; consequently, the
driver is unable to access the specified
device.
–10249 intConfigError The interrupt configuration is incorrect
given the capabilities of the computer
or device.
–10250 dupIntError The interrupt levels for two or more
devices are the same.
–10251 dmaConfigError The DMA configuration is incorrect
given the capabilities of the
computer/DMA controller or device.
–10252 dupDMAError The DMA channels for two or more
devices are the same.
–10253 jumperlessBoardError Unable to find one or more jumperless
boards you have configured using the
NI-DAQ Configuration Utility.
–10254 DAQCardConfError Cannot configure the DAQCard because
1) the correct version of the card and
socket services software is not installed;
2) the card in the PCMCIA socket is not
a DAQCard; 3) the base address and/or
interrupt level requested are not
available according to the card and
socket services resource manager. Try
different settings or use AutoAssign in
the NI-DAQ configuration utility.
–10255 remoteChassisDriverInitError There was an error in initializing the
driver for remote SCXI.
Table A-1.
Status Code Summary (Continued)
Status Code Status Name Description