Welding System User Manual

Appendix A Status Codes
NI-DAQ FRM for PC Compatibles A-2
© National Instruments Corporation
–10007 badChanError A channel is out of range for the board
type or input configuration; or the
combination of channels is not allowed;
or the scan order must be reversed
(0 last).
–10008 badGroupError The group is invalid.
–10009 badCounterError The counter is invalid.
–10010 badCountError The count is too small or too large for
the specified counter; or the given I/O
transfer count is not appropriate for the
current buffer or channel configuration.
–10011 badIntervalError The analog input scan rate is too fast for
the number of channels and the channel
clock rate; or the given clock rate is not
supported by the associated counter
channel or I/O channel.
–10012 badRangeError The analog input or analog output
voltage range is invalid for the specified
channel.
–10013 badErrorCodeError The driver returned an unrecognized or
unlisted error code.
–10014 groupTooLargeError The group size is too large for the board.
–10015 badTimeLimitError The time limit is invalid.
–10016 badReadCountError The read count is invalid.
–10017 badReadModeError The read mode is invalid.
–10018 badReadOffsetError The offset is unreachable.
–10019 badClkFrequencyError The frequency is invalid.
–10020 badTimebaseError The timebase is invalid.
–10021 badLimitsError The limits are beyond the range of the
board.
Table A-1.
Status Code Summary (Continued)
Status Code Status Name Description