User's Manual

Firmware

This radio module is only compatible with authorized firmware images from National Instruments. It prevents

unsigned firmware images from being remotely deployed.

FCC Information

This radio module meets the requirements of the following Radio Equipment standards:

• FCC 47 CFR Part 15C: Intentional Radiators

• RSS-247: DTSs, FHSs, and LE-LAN

Federal Communications Commission Interferences Statement

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in

accordance with the manufacturer's instruction manual, may cause interference with radio and

television reception. This equipment has been tested and found to comply with the limits for a Class A

digital device pursuant to Part 15 of the FCC Rules.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause

undesired operation.

Note This equipment has been tested and found to comply with the limits for a Class A digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference when the equipment is operated in a commercial environment. This equipment

generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance

with the instruction manual, may cause harmful interference to radio communications. Operation of this

equipment in a residential area is likely to cause harmful interference in which case the user will be

required to correct the interference at his own expense.

Note The FCC regulations provide that changes or modifications not expressly approved by NI could void

your authority to operate this equipment.