User Manual
Table Of Contents
- Packing List
- Quick Installation and Operation Guide
- Introduction
- 1 System Requirements
- 2 Terminology Used in this Guide
- 3 Familiarization and Installation
- 4 Driver Installation and Operation
- 5 Utility Installation, Startup, and Shutdown
- 6 Operation
- 7 Utility Command Reference
- Appendix A: Character Conversion Charts
- Appendix B: Troubleshooting
- Appendix C: Technical Support
- Appendix D: Limited Warranty
- Appendix E: Specifications
- Appendix F: Channels and Regulations
20
2. Find out the network’s SSID, WEP, mode, and channel settings from the
Site Survey
results.
If the network does not appear immediately in the
Site Survey
listing, choose
Search
and wait a few seconds.
If the mode is ad-hoc, note the channel setting. If WEP is enabled, obtain detailed WEP
settings from the network installer or operator.
3. In the
Connection Profiles
section, choose
New
.
The
New Profile
dialog box will appear.
Figure 16. The New Profile dialog box
4. Decide on a name for the profile and type it in.
The name can be any length. It must not contain spaces.
5. Go to the
SSID
control (by clicking it or pressing
Tab
) and type in the SSID.