User's Manual

14
Instant
Wave High Speed
PCI/PC Card
p
step5. Insert the Windows NT driver diskette into drive a (or b) and then type
a:\winnt (or b:\winnt)
step6. Click OK. The Select OEM Option dialog box will open.
step7. Select the correct adapter and click OK. If PC Card is selected, the
dialog box for setting the Interrupt number and I/O address will be
shown. Users can specify a different Interrupt number and I/O address
for this adapter if there is a conflict with an existing card in the
computer
step8. Click OK. The InstantWave PCI Adapter Setup dialog box will open.
Select the Network Type and Carrier Set. If the station is connected to
an Access Point, Infrastructure mode must be specified. Select Ad Hoc
mode to make a peer to peer connection to other wireless stations. If
the country of operation is different from the country in which the
product was purchased, the user can change the carrier set. All wireless
stations and Access Points must use the same Carrier Set in order to
communicate. The Domain name should be the same as the network
domain to which the station will be connected
step9. Click OK. The Roaming dialog box will open.
step10. When Roaming is enabled, the station is allowed to roam to another
Access Point under the same Domain Name whenever the radio signal
quality of the currently connected AP is below an acceptable level.
Click OK. The Security dialog box will appear.