Instruction Manual

11
4. Place remaining headers (C) over sleeves at positions H1, H2, H3, H4, H6, H7, H8 & H9 (Diagram A) on
base angles (A). Secure with components from header assembly hardware kit (K, L, M, N), do not tighten
bolts.
RUB RAIL ASSEMBLY
5. Place one rub rail (B) between 2 headers with flat side to the inside of the corral. At the entry points of the
corral attach the end of the rub rail with; 3/8 x 2-3/4 HHCS, 3/8 flat washer, lock washer and hex nut (photo
A). Place a second rub rail between the 2 headers next to the rub rail that was just installed. Secure the open
end of the first rub rail and the end of the second rub rail with the same hardware. Repeat in all openings
between headers.
photo A
6. Check cart corral and square up if necessary. Then go back through completed framework and tighten all
joints.