Use and Care Manual

Choose your desired shelf location on the wall. Using the Wall Anchor Spacing Dimensions graphic

below, begin to line up & mark where you will need to drill holes for the Wall Anchors (5)(6).

Using a 5/16” drill bit, drill holes on your marks then push the Wall Anchors (5)(6), for the proper wall

type, into the holes.

Finally, fasten a M4*50mm Screw (4) into each of the top holes, while leaving a small gap between

the back of the screw and wall to allow for the unit to hang on. (Do NOT fasten a screw into the

bottom hole yet).

Step 4—Option 2: Wall Mounting

Important Note:

Remember your options from Step 1? The

graphic above shows the hole spacing

dimensions for both Vertical Support

Frame (A) spacing options.

For this step, you will only need to drill 3

holes respective to which set of holes you

chose earlier when completing Step 1.

Wall Anchor Spacing Dimensions

Important Note:

Part 5 is for non-drywall

applications.

Part 6 is for drywall applications.