Use and Care Manual

You’re almose done! Time to mount the shelf. Follow the instructions from this page if mounting on

the ﬂoor. Skip ahead to page 9 if mounting on the wall.

Set assembled product in its desired location against the wall. Adjust the back of the Metal Bracket

(7) so it touches the wall, then fully tighten M4*15mm Screw (8) into the bottom of the Shelf (B).

Next, using the back of the Metal Bracket (7) against the wall, mark where to drill the hole for the

wall anchor that you will use to tether the shelf to the wall. Using a 5/16” drill bit, drill a hole on your

mark, then push the Wall Anchor (5)(6) for the proper wall type into the hole.

Finally, fasten M4*50mm Screw (4) through the Metal Bracket (7) into the Wall Anchor (5)(6).

Step 4—Option 1: Floor Mounting

Important Note:

Part 5 is for non-drywall

applications.

Part 6 is for drywall applications.