Use and Care Manual

6
How to use
cam locks
Did you know?
Cam locks are used to join two panels together,
usually the edge of one to the flat side of another.
If a cam lock seems to be spinning in place or is not “catching” or pulling the panels together as expected ,
first remove the cam lock & try again while making sure that everything is properly positoned & oriented .
If you are still having issues getting things work ing as expected, first remove the cam lock then unscrew
the cam bolt slightly (less than 1 complete turn) to see if that helps with the alignment of the cam lock & bolt.
Still
having
issues?
First, your cam bolt (or cam pin) will need to be
properly inserted into the flat side of the board.
Important Note: O nly tighten the cam bolt until
it is secure. Do not over-tighten.
Next, you will fit the proper hole on the edge of
the associated joining panel over the cam bolt.
Important Note: When installed properly, the
head of the cam bolt will be visible through the
larger hole on the side of the joining panel.
Next, you will notice the cam lock has a “C”
shaped back. Commonly, an arrow on the
front of the cam lock points in the same
direction as the open section on back.
Using these as your cue, insert the cam
lock into the large hole so the opening of
the “C” fits over the head of the cam bolt.
Using a screwdriver, you will turn the cam
lock until it stops, usually between 130º or 180º.
You will feel the panels pulling closer until
they are secured.
Important Note: Only turn the cam lock until
the panels are fully engaged & feel secure.
Turning too far may lead to hardware failure.