Use and Care Manual

10
Now it’s time to secure the
Fixture (1) to the Cross Bar (C)
on your pre-installed electrical
box using the Decorative Nuts
(E). Be sure that you have all
of the excess wire tucked into
the electrical box.
To properly fasten the Decorative
Nuts (E), thread in or out to adjust
for proper threading length.
Use 2 Type G50 bulbs (not
included) 120V 60Hz AC only
Now for the final touch:
install the light bulbs! We
recommend 2 type G50 bulbs.
And voila, let there be light!
Step 9
Step 10
Problem
The bulb will not light.
The fuse blows or circuit
breaker blows when the light
is turned on.
Possible Causes
The bulb is burned out.
The power is o.
The circuit breaker is o.
There is an exposed wire.
Solutions
Replace the light bulb.
Ensure the power supply is on.
Ensure the circuit breaker is in the ON position.
Discontinue use of the light.
Contact a qualified electrician or reach out to
our Customer Happiness team at
[e-mail] or 1-866-619-1004.
Troubleshooting
E
E