Use and Care Manual

14
You made it to the last step!
You’ve been doing such an
impressive job that we’ve
decided to make this step
the easiest. Simply screw
in the light bulb, and then
you’re done!
We recommend using Type
A19 bulbs (not included) with
a maximum wattage of 60W.
Step 11
Problem
The bulb will not light.
The fuse blows or circuit
breaker blows when the light
is turned on.
Possible Causes
The bulb is burned out.
The power is o.
The circuit breaker is o.
There is an exposed wire.
Solutions
Replace the light bulb.
Ensure the power supply is on.
Ensure the circuit breaker is in the ON position.
Discontinue use of the light.
Contact a qualified electrician or reach out to
our Customer Happiness team at
[e-mail] or 1-866-619-1004.
Troubleshooting
120V 60Hz AC Only