2.
I. Location of Functions A.Transmitter(NTJD800) 1. 2. 3. 4. 5. 6. 7. 8. 9.
B. Rear Round Speaker(NTID800) 10. 11. 12. 13. 14. 15. 16.
Front view 13 14 Rear View 15 REV0B 16 Page 4 of 11 July 02, 2005
Accessories: Audio Cable(Stereo) Adaptor(6V 500mA) for Transmitter Adaptor(15V 800mA) for Speaker REV0B Page 5 of 11 July 02, 2005
Connecting the System I. Powering the Transmitter Connect the small, round plug from the transmitter AC power adaptor to the transmitter power input jack and plug the other end of the adaptor into any standard 120V AC wall outlet. Press the ON/OFF button of the transmitter. The Red LED on the power light should be ON. II. Connecting to an Audio Source Connect the audio cable to the LINE IN jack of the transmitter and plug the other end to audio source (e.g. LINE OUT of DVD player).
Turn the LINE IN selection switch to LINE IN. The Audio/Video Switch is for latency select. Usually set at Audio for music listening.
III. Powering the Speakers Insert the small, round plug from one speaker AC power adaptor into the speaker power input jack Plug the other end of the speaker AC power adaptor into any standard 120V AC wall outlet. Note: Be sure to use the speaker AC power adaptors rated 15V DC 800mA 1. After powering up the speaker, the power/RSSI indicator will start blinking in green color and searching for transmitter. 2. If transmitter is found and connected, the power/RSSI indicator will turn green. 3.
IV. Audio Muting When audio source is cut off for 3 minutes, the speaker will be muted. But if audio signal resumes, the muting will be disabled and speaker will be ON again. V. Active/Passive Speakers The 2.4GHz system can support infinite no. of receivers(speakers or headphones). However, the no of receivers increase, the performance will be downgraded, i.e. transmission range will be reduced. The first two receivers paired with the transmitter are called “Active” speaker.
REV0B Page 10 of 11 July 02, 2005
The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. Nasaco NTID - 800 TESTED TO COMPLY WITH FCC STANDARDS FOR HOME OR OFFICE USE This device complies with part 15 of the FCC rules.
