User's Manual

http://www.nasa-com.com
Page 5 of 7
Troubleshooting:
If you do not hear a dial tone when you try to make a phone call.
1. Make sure your Battery Pack is fully charged and inserted in your Headset
and Base Unit.
2. Confirm the Power Switches on both Base Unit and Headset are on the ON
position.
3. Be sure that the green LEDs is ON for both Base Unit and Headset when
you push the keypad.
4. Make sure that the cable is compatible with your cellular phones. For most
of the cellular phones, ”Headset" will display on the screen if the cable is
connected correctly.
5. Confirm the volume of your cellular phone is set to the maximum level.
6. Try pushing the volume button on the
headset
to increase the audio level.
Battery Charging:
Step 1) Plug the AC to DC adaptor into the electric socket. Then connect the
adaptor to the Battery Charger shown in Fig. 7.
Step 2) Insert the battery pack into the Charger (Fig.6). Three battery packs can
be charged at the same time independently.
Step 3) The red LED on the Charger will be ON (Fig. 6) when the battery is
being charged.
Step 4) After approximate 10 hours, the battery pack will be fully charged and
the red LED will be OFF.
Step 5) Remove the battery pack from the Charger and insert it to the Base Unit
or Headset for battery replacement. The charged battery will last for
around 2.5 hours talk time or 150 hours in standby mode. It is
recommended to put the discharged battery packs into the charger for
overnight charging.