User’s Manual Narwal FREO Robot Vacuum and Mop Model: YJCC012
Contents Dear user, Thank you for choosing Narwal. To ensure the best experience possible, please read this manual and related illustrations carefully before using our product and save it for future reference. Due to continuous updates, the actual product may not be completely consistent with the description in the manual, please refer to the actual product.
Important Safety Instructions When using an electrical robot, basic precautions should always be followed, including the following : READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE To Reduce the Risk of Fire and Electric Shock due to internal component damage, use only NARWAL cleaning fluid intended for use with this appliance. See the Cleaning Fluid section of this manual. Place the cords from other appliances out of the area to be cleaned.
• Do not use your robot without dust bag and/or filters in place. • Prevent unintentional starting. Ensure the switch is in the off-position before connecting to lower the battery pack, picking up or carrying the appliance. Please do not touch the power switch when holding the robot or the base station. Please do not hold the robot or the base station while they are charging.
The laser distance sensor of this product meets the standards for Class I Laser Products in IEC 60825-1: 2014 and will not generate hazardous laser radiation. Note:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Product Introduction CAN ICES-003 (B)/NMB-003(B) Package Contents This device contains license exempt transmitter(s)/receiver that complies with Innovation, Science Main Units and Economic Development Canada’s license exempt RSS(s). Operation is subject to the following two conditions:1.This device may not cause interference. 2. This device must accept any interference, including interference that may cause undesired operation of the device.
Product Overview Base station Automatic cleaner feeding slot Power jack Dirty water level indicator float Base station touchscreen Water tank handles Clean water tank latch Picking cavities of the base station Speaker Dirty water tank latch Clean water tank Base station cleaning components Dirty water tank Cleaning tray Cleaning base 04 05
Robot Bottom Reset button Cliff sensor Cleaning hook Carpet sensor Cover Cliff sensor Roller brush Vacuum inlet Tire Tire Cliff sensor Cliff sensor Infrared sensor Omni-directional wheel Bumper Side Operation button Dustbox Pressure sensing radar cover Filter cover Filter handle Filter Picking cavity Charging-electrode Wall-following sensor Dustbox open /close button 06 07
Control Panel Overview Standby Mode Robot Control Panel 1. Click the Standby Mode. 2. Click "Confirm". Button/indicator light Operations and Functions Ring button Click: Clean the whole house Press and hold the button for 3 seconds: Power on/off Ring indicator light Solid white indicator: The device is powered on/drying/charging 3. Enter Standby Mode.
Use Notices This product is only used to clean floors in household environments, and cannot be used 5. To prevent damages to the device, do not place outdoors (such as open balconies), areas other than floors (such as sofas or window sills), the robot near any heat or water sources (such as high places, or commercial/industrial environments. radiators or faucets). 1. Do not use in areas with steep drop-offs (such as lofts or top of furniture) without guardrails Other Notices 6.
22. To transport the robot, make sure that it is turned off. It is recommended to transport it in the original packaging. 23. It is hazardous for the rotating brush to touch the power cord. Arrange the wires neatly before use. 24. To prevent the floor from being scratched, ensure that there is no sharp large-grained gravel or sharp objects on the floor when mopping. Specifications Specifications Robot Base station Dimensions: 350*351.
