Installation Instructions

1.ĢÍĩåÍåĄĄöÃĮŘÍĞèþÃøĮÉÍÉĩĄĞÍýĄŁÍ
hair tangled on the side brushes.
3.Replace damaged side brushes with new ones if any.
uÍěø«ÃÍýÍþĩĢĩÍěĢɎ
2.uÍýĄŁÍĄĩåÍĞÉÍÂĞèĢ«Ř«ÃåÍÉ
to the vacuuming module.
Vacuuming module
It is recommended to clean it every two weeks and replace
it
s side brushes every three months
Mopping module
It is recommended to replace the mop every one to three months
Note: The vacuuming module can be washed
di
rectly with water and dried before it is used
again.
1. rø«ÃÍĩåÍŁ«ÃĮĮýèþàýĄÉĮøÍ«ĢĢåĄłþèþĩåÍŖàĮĞÍ«ÂĄŁÍɌ
2. Hold the brush head and pull it up.
1. Remove the old mop.
2. Ř«Ãå«þÍłýĄěĩĄĩåÍýĄěěèþàýĄÉĮøÍ«øĄþàłèĩåèĩĢěĞĄŖøÍɌ
3. rĞÍĢĢĩåÍýĄěłèĩåå«þÉĩĄ«Ř«ÃåèĩŖĞýøňɌ
3. Install the side brush with an L mark on the
left side of the vacuuming module, and the
one with an R mark on
the right side of the
vacuuming module. (You must pay
«ŘÍþĩèĄþ
to the left and right directions of the side
brush during installation. Incorrect installation
may lead to brush deformation).
CLEANING AND MAINTENANCE CLEANI
NG AND MAINTENANCE
43 4
4
1
. Lift the handle of the cleaning board, and
take
them out.
1.Pull out the caster wheel and remove the
debr
is on the caster wheel and its spindle.
(There is a metal sheet inside the caster
wheel, please do remember to put
it back)
2.
Re-install the caster wheel and press
to fasten it.
3. uÍýĄŁÍĢĩ«èþĢèþĩåÍÂĄŘĄýĢøĄĩĄß
the base
station.
4. Put the cleaning board back in place
2. Rinse the cleaning board.
øÍ«þèþàÂĄ«ĞÉ«þÉÂĄŘĄýĢøĄĩ
It is recommended to clean them once every two weeks
«ĢĩÍĞłåÍÍø
It is recommended to clean it monthly