Full Product Manual

*NEFB27H, NEFB29H REMOTE
CONTROL ILLUSTRATED
EN
W415-1454 / F / 03.16.17
13
4.2 OPERATING BY REMOTE CONTROL
!
WARNING
TO AVOID DANGER OF SUFFOCATION KEEP THE PACKAGING BAG AWAY FROM BABIES AND
CHILDREN. DO NOT USE IN CRIBS, BED, CARRIAGES OR PLAY PENS. THIS BAG IS NOT A TOY.
KNOT BEFORE THROWING AWAY.
A. The power button can be used to turn the appliance on/off. Pressing
this button activates the power to the appliance. Pressing the power
button again will turn off the appliance. The ember and log will fade after
4 seconds after turning off the appliance.
B. To adjust the flame brightness and ember log light, press the flame
button . There is one ember log light and three flame brightness levels
to cycle through and then an off setting ( LL, F1, F2, F3 and then F0).F3
is the brightest flame level, LL is the ember log light only.
C. To control the thermostat function press the thermostat button . There
are 7 temperature settings (61°F, 64°F, 70°F, 75°F, 81°F 85°F and off).
The default setting will display Fahrenheit. Press the thermostat button
to cycle through the settings. Once you have selected the desired
temperature the heater will automatically operate until that temperature
is reached. When the room temperature is 2 degrees lower than the
temperature setting, the heater will turn on.
D. To activate the heater and blower, press the heater button , the
blower will turn on. Press the heater button again to set desired low
or high heat temperature; press the heater button again to turn off the
heater.
E. The timer controls all operating modes of the appliance. To activate the
timer, press the timer button , the icon will illuminate and the time will
appear on the LED display. To choose the desired time, continue
to press the timer button, there are 8 settings (30mins,1h, 2h, 3h,
4h, 5h, 6h and off). The fireplace will turn off at the setting time.
F. To activate the decoration light, press the light button .There are three settings to cycle through
and then an off setting (d1, d2, d3 and then d0). d1 white colour, d2 colour cycles from White /
Orange / Blue / Orange-Blue / White-Orange / White-Blue. It will take 8.5 seconds to switch from
one colour to the next when in d2 setting, d3 will lock to a desired colour (Only NEFB27H and
NEFB29H models have the decoration light feature).
G. To turn off the appliance, press the power button once on the remote, or press the power button
once on the control panel on the unit.
NOTE: This hand held remote control must remain within 6 meters or 19 feet of the appliance
to be effective.
NOTE: When operating the remote control, it must be directed towards the front center of the appliance.
4.3 REMOTE BATTERY INSTALLATION
1. To replace the existing battery, remove the
battery holder.
2. To remove the battery holder, turn remote onto
front side and press the left side lever towards
the center while pulling the battery holder out
using the slot provided.
3. Replace existing battery, type CR 2025, with a
new battery and reinstall the battery holder into
the remote by sliding it into position, as shown.
4. Battery cover is secure onto the remote control
when a "CLICKING" noise is heard.
REMOTE
(REAR SIDE)
BATTERY (CR 2025)
BATTERY COVER