Use and Care Manual
NOTE: The appliance tabs come bent. You must bend the tab flat by hand when fully recessing the
appliance into the wall, Figure 4.
FIG. 4
A. Remove the mesh trim front, refer to "MESH TRIM FRONT REMOVAL " section for removal
instructions.
B. Install the rubber feet onto the bottom of the appliance for stability, refer to "RUBBER FEET
INSTALLATION" section for instructions.
C. Install the top and bottom brackets provided.
D. Insert the appliance into the mantel and secure it with the brackets or refer to "ELECTRIC
FIREPLACE MANTEL" installation manual for proper appliance installation instructions.
E. Place the crystal embers along the media tray, refer to "CRYSTAL EMBER INSTALLATION" section.
F. Reinstall the mesh trim front.
3.4 MANTEL INSTALLATION
3.4.1 INSTALLING THE APPLIANCE INTO A MANTEL
EN
W415-2172 / 08.08.16
13