Installation Guide

W415-1698 / 12.20.16

6.7 WIRE HARNESS REPLACEMENT

1. To replace the existing battery remove the

battery holder.

2. To remove the battery holder turn remote onto

rear side and press the left side leaver towards

the center while pulling the battery holder out

using the slot provided.

3. Replace existing battery, type CR 2025, with a

new battery and reinstall the battery holder into

the remote by sliding it into position, as shown.

REMOTE

(REAR SIDE)

BATTERY HOLDER

BATTERY (CR 2025)

NOTE: The remote control must remain within 5 meters or 17 feet of the appliance to be effective, this

range may be reduced when battery power is depleted.

NOTE: The remote control has a removable plastic tab to prolong the battery life while shipping,

remove the tab for the remote control to function.

1. Remove wire connections from the PCB and heater/blower/high limit switch assembly.

2. Replace wire harness assembly. Refer to wiring diagram.

6.8 REMOTE BATTERY INSTALLATION

PCB WITH WIRE CONNECTORS PCB WITHOUT WIRE CONNECTORS