Installation and User Guide

W415-2172 / A / 11.10.17

FIG. 2

The mesh trim front must be removed and the appliance must be secured in its ﬁnal location before the crys-

tal embers are installed.

A. Carefully place crystal embers into the bottom media tray on

the front of the appliance as illustrated. Apply an even layer

from side to side.

B. Ensure that no crystal embers touch the mesh trim front during

install. Avoid crystal embers scratching/tearing mesh.

A. Remove the 2 screws from the top of the appliance. See illustrations below.

B. Have 2 people lift the mesh trim up and away from the appliance, holding the mesh trim vertical - not

ﬂat - while carrying. Place the mesh trim face down onto a soft, non-abrasive surface, being careful

not to ﬂex the mesh trim.

C. Install the crystal embers. Refer to "CRYSTAL EMBER INSTALLATION" section. Install the front

mesh trim by aligning with the pins on the appliance. This ensures the touch display panel performs

properly.

FOR WALL-MOUNT, PARTIAL-RECESS AND MANTEL-INSTALLED APPLIANCE ONLY:

4.2 MESH TRIM FRONT REMOVAL

4.3 CRYSTAL EMBER INSTALLATION