Owners Manual

9
www.napoleongrills.com
WARNING! If these instrucons are not followed exactly, a re causing death or serious injury may
occur.
Propane Cylinder Specicaons
A dented or rusty cylinder may be hazardous and should be checked by your propane supplier. Never use a
cylinder with a damaged valve. Use only a propane supply cylinder constructed and marked in accordance with
the specicaons for LP-gas cylinders of the Naonal Standard of Canada, CAN/CSA-b339, Cylinders, Spheres
and Tubes for Transportaon of Dangerous Goods; and Commission, as applicable or the Specicaons for
LP- Gas Cylinders of the U.S. Department of Transportaon (D.O.T.). This appliance has been designed for use
with a 20 lb. (9.1 kg) or 30 lb (13.6 kg) size propane cylinder only (not supplied).
The propane cylinder must be provided with a cylinder connecon device compable with the connecon for
outdoor appliances. The propane cylinder must be provided with a shut-o valve terminang in a propane
cylinder valve type QCC1, and a safety relief device having direct communicaon with the vapor space of the
cylinder. The cylinder supply system must be arranged for vapor withdrawal and the cylinder shall include a
collar to protect the cylinder valve. The cylinder shall incorporate a listed OPD (overll protecon device). Do
not store a spare LP-gas cylinder under or near this appliance. Never ll the cylinder beyond 80 percent full.
Use only the pressure regulator and hose assembly provided with this appliance. Replacement pressure
regulators and hose assemblies must be specied by the manufacturer. The regulator supplies a pressure of 11 inches. water
column to the appliance and has a QCC1 type ng. Cylinders to be used with this unit must be supplied with
a QCC1 cylinder valve. A QCC1 cylinder has a posive seang connecon, which will not allow g as ow unl a
posive seal has been achieved. It is also equipped with an excess ow device. In order to aain full ow to
the appliance, the valve must be in the o posion when the cylinder valve is turned on.
WARNING! A re will result if the gas supply hose makes contact with the underside of the appliance.
Gas Hook-Up Instrucons
LP (Propane) Gas
Aach cylinder retaining bracket supplied to the base of the cylinder. Then secure to the surface to which it
sits. Cylinder should be on a level surface.
Cylinder Retaining Bracket
1. Fasten the bracket to the boom of the propane bole using bolt
and nut supplied.
2. Tighten the lag screw into the mounng surface leaving approximately
1/4” of thread above the surface.
3. Slide propane bole into posion so that the bracket slides under
the head of the lag screw.
4. Tighten the lag screw onto the bracket.
5. For fastening to a concrete surface a concrete anchor will be
required. (Not supplied)
Cylinder Connecon: Ensure the gas regulator hose is kink
free. Remove the cap or plug from the cylinder fuel valve.
Insert the black QCC1 regulator nipple onto the QCC1 fuel
valve. Hand ghten clock wise. Do not use tools. Leak test
all joints prior to using the appliance. A leak test must be
performed annually and each me a cylinder is hooked up
or if a part of the gas system is replaced.
If this appliance is to be connected directly to a house
propane gas supply line, follow the instrucons for the
natural gas hook-up.