Owners Manual

4
www.napoleongrills.com
General Informaon
This gas appliance is cered under Canadian and American Naonal Standards, ANSI Z21.97-2010 “Standard
for Outdoor Decorave Gas Appliance” and CAN/CGA 2.17-M91 (R2009) “Gas-Fired Appliance for use at High
Altude” and should be installed to conform with local codes. In absence of local codes, install to the current
CAN/CSA-B149.1 Propane Installaon Code in Canada or to the Naonal Fuel Gas Code, ANSI Z223.1 in the
United States.
This appliance should be installed and serviced by a qualied installer to conform with local codes.
Installaon pracces vary from region to region and it is important to know the specics that apply to your
area, for example: in Massachuses State:
• The appliance o valve must be a “T” handle gas cock.
• The exible connector must not be longer than 36 inches.
The installaon must conform with local codes or in the absence of local codes, with the Naonal Fuel Gas
Code ANSI Z223.1/INFPA 54 in the United States or CSA B149.1, Natural and Propane Installaon code in
Canada.
The appliance and its individual shut o valve must be disconnected from the gas supply piping system during
any pressure tesng of the system at test pressures in excess of 1/2 psig (3.5kPa).
This appliance must be isolated from the gas supply piping system by closing its individual manual shut o
valve during any pressure tesng of the gas supply piping system at test pressures equal to or less than
1/2 psig (3.5kPa).
The following clearances to combusble materials must be maintained:
Sides (all around) - 24 inches (610mm)
Top - 72 inches (1830mm)
• Always keep the appliance area clear and free from
combusble materials, gasoline, and other ammable
vapours and liquids.
• Do not locate appliance where it can get excessively
wet.
• Do not use this appliance if any part has been
under water. Immediately call a qualied service
technician to inspect the unit and to replace any
part of the control system and any gas control,
which has been underwater.
Geng Started
1. Remove all of the parts from the carton. Use the parts list to ensure all necessary parts are included.
2. Do not destroy packaging unl the pao ame has been installed and operates to your sasfacon.
3. Choose a locaon that meets the clearance to combusbles as outlined in the specicaon secon of this
manual. Take into consideraon the need for clear and easy access to the on/o valve AFTER the appliance
is installed and connected to the gas supply in order to safely turn o the burner.
4. Most stainless steel parts are supplied with a protecve plasc coang that must be removed prior to using
the pao ame.
5. Read and follow all instrucons in this manual before installing or servicing this gas pao ame.
If you have any quesons about assembly or pao ame operaon, or if there are damaged or missing parts
please call our Customer Care Department at 1-866-820-8686 between 9 AM and 5 PM (Eastern Standard Time).
WARNING! This appliance is designed for non-combusble enclosures only, and must be installed and
serviced by a qualied installer to local codes.