Installation and Operating Instructions

12
W415-0806 / C / 09.13.11
The upper louvres must be removed to allow the door
to be opened or closed. To access the lower door latch,
open the valve control door. Release the top and bottom
door latches, located at the right side of the door.
NOTE: The protective wrap on plated parts is best
removed when the assembly is at room temperature
but this can be improved if the assembly is warmed,
using a hair dryer or similar heat source.
4.2 DOOR REMOVAL AND INSTALLATION
DOOR LATCH
!
WARNING
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
THE DOOR LATCHES ARE PART OF A SAFETY SYSTEM AND MUST BE PROPERLY ENGAGED. DO
NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRES OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
75.1
A. Remove the 3 screws from the location shown in
the base of the fi rebox.
B. Secure the grate to the fi rebox base using the 3
screws removed.
4.3 GRATE INSTALLATION