Installation Instructions
9
www.napoleongrills.com
This grill is designed for masonry, enclosures only, and must be installed and serviced by a
qualied installer to local codes. Access must be provided in the enclosure for drip tray removal and cleaning.
1. Aach side mounng brackets to each side of the grill using #14 x 1/2" screws (N570-0086). The wings on
the rear trim should be under the side mounng brackets.
2. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be applied
to each wing of the rear trim.
3. Aach the supplied brackets ush with the front of the opening as per the dimensions in the above drawing
(fasteners not included).
4. Lower the unit in place ensuring the brackets installed in the previous step engage between the control
panel and the base bracket. Connect the ex line to the ng at the end of the manifold.
5. The enre installaon must be leak tested before operang the unit.
N570-0086
N080-0215
N715-0083
N570-0086
N080-0215
N080-0155
N010-0281
W445-0031