User Manual

7
www.napoleon.com
N415-0564-AU JUN 17.20
This unit includes an internal regulator which stabilizes
the gas pressure and improves grill performance. This
regulator cannot be adjusted. There is a pressure tap
located on the side of the regulator. It can be used by
a qualied service person when servicing the grill to
determine if the regulator is funconing properly. The
screw within the pressure tap must always be kept ght,
except when performing a pressure test on the regulator
(qualied service personnel only).
BUILT IN NATURAL GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and
piping should be located as shown in the built-in instrucons. A exible metal connector is included to
simplify the installaon of the unit. Connect this exible metal connector to the are ng (3/8” SAE 45
O
Flare Connecon 5/8-18 UNF thread)
Connect the other end of the connector to the supplied gas regulator. Ensure that the exible metal
connector is protected from damage if it needs to pass through any parons. The installaon must be
performed by a licensed gas er in accordance with AS/NZS 5601, and all connecons must be leak
tested before operang the grill.
Do not use a hose to connect the unit. The supplied regulator with 3/8” SAE 45
O
Flare Inlet Connecon
(5/8-18 UNF thread) must be connected with rigid pipe, copper tube or an approved exible metal
connector which complies with with AS/NZS 5601. The gas supply pipe must be suciently sized to supply
the kPA specied on the rang plate, based on the length of the piping run. If installing a side burner,
a separate line must be branched o to the side burner unit and enter the side burner opening at the
specied locaon.
WARNING! Built in units are supplied with a drip pan which holds only a minimal amount of
grease. To prevent grease res, the pan must be cleaned aer each use.
WARNING! Access must be provided to the inside of the enclosure to make gas connecons.
DANGER! Read all instrucons carefully before operang the grill. Failure to follow these
instrucons exactly could result in a re causing serious injury or death. The enre installaon must be
leak tested before operang the grill.
Note: The gas grill is designed to operate at a test point pressure of 1.00 kPA and must be checked aer
installaon by turning all burners on and measuring at the regulator outlet test point provided.
!
!
Specicaons
ORIFICE SIZES
ULPG NG
MAIN FLAME BURNER
1.2 MM 1.9 MM
MAIN INFRARED BURNER
#58 #50
REAR BURNER
#58 #48