User Manual

3
www.napoleon.com
N415-0564-AU JUN 17.20
WARNING! Failure to follow these instrucons could result in property damage, personal injury
or death. Read and follow all warnings and instrucons in this manual prior to operang grill.
!
Safe Operang Pracces
This gas grill must be assembled exactly according to the instrucons in the manual. If the grill was
store assembled, you must review the assembly instrucons to conrm correct assembly and perform
the required leak tests before operang the grill.
Read the enre instrucon manual before operang the gas grill.
This gas grill must be used only outdoors in a well-venlated space and must not be used inside a
building, garage, screened-in porch, gazebo or any other enclosed area.
This gas grill must not be installed in or on recreaonal vehicles and/or boats.
Do not locate unit in windy sengs. High winds adversely aect the cooking performance of the gas
grill.
Do not modify this appliance.
Do not operate unit under overhead combusble construcon.
The non-combusble installaon must be located to maintain proper clearance to any adjacent
combusble construcon, such as combusble exterior walls of residenal buildings (27” (686 mm) to
rear of unit, 24” (610mm) to sides). Addional clearance of 24” (610mm) is recommended near vinyl
siding or panes of glass.
Gas must be turned o at the gas supply valve when the gas grill is not in use.
If the enclosure is to house a Universal Liqueed Petroleum Gas cylinder, the tank poron of the
enclosure must be venlated according to local codes, and must not have communicaon with the
cavity used to enclose the gas grill. A Universal Liqueed Petroleum Gas cylinder tank cannot be
stored below the gas grill.
When the Universal Liqueed Petroleum Gas cylinder is connected to the appliance, the gas grill and
cylinder must be stored outdoors in a well-venlated space.
Inspect the fuel supply hose before each use. If there is evidence of excessive abrasion or wear or the
hose is cut, it must be replaced prior to using the gas grill with a replacement hose assembly specied
by the grill manufacturer.
Periodically check the test date on the ULPG gas cylinder to ensure it is within its service life
specicaon. If required, contact an approved tesng facility or ULPG supplier for re-cercaon or
replacement.
Leak test the unit before inial use, annually, and whenever any gas components are replaced.
Follow lighng instrucons carefully when operang grill.
Burner controls must be o when turning supply cylinder valve on.
The lid is to be closed during the gas grill preheang period on all models except the BISZ300NFT/PFT
and the built-in side burner BISB245.
The BISZ300NFT/PFT and the built-in side burner BISB245 are supplied with a at cover for storage
and protecon from the elements. Never place this cover on the grill while hot or operang. Allow
grill to cool completely before covering.
Adults and especially children should be alerted to the hazards of high surface temperatures. Young
children should be supervised near the gas grill.
Do not place arcles on or against this appliance.
Do not leave grill unaended when operang.
Do not light burners with lid closed.
Do not use or store ammable materials in or near this appliance.
Do not operate rear burner with main burners operang.
Do not move grill when hot or operang.
Keep any electrical supply cord and fuel supply hose away from any heated surfaces.
Do not spray aerosols in the vicinity of this appliance while it is in operaon.
Ensure sear plates are posioned properly according to sear plate installaon instrucons. The holes
must be towards the front of the gas grill (if applicable).
Clean grease tray and sear plates regularly to avoid build-up, which could lead to grease res.
Remove warming rack before lighng rear burner. The extreme heat will damage the warming rack.
Inspect infrared burner venturi tube for spider webs and other obstrucons periodically. Clean the
tubes completely if you nd any such obstrucons.
Do not allow cold water (rain, sprinkler, hose, etc.) to come in contact with heated unit. A large
temperature dierenal can cause chipping in the porcelain.
Do not allow cold water (rain, sprinkler, hose, etc.) to come in contact with ceramic burners. A large
temperature dierenal can cause cracking in the ceramic le.
Do not use a pressure washer to clean any part of the unit.