This gas grill must be used only outdoors in a well-ventilated space and must not be used inside a building, garage, screened-in porch, gazebo or any other enclosed area. APPLY SERIAL NUMBER LABEL FROM CARTON Serial No. XXXXXX000000 MODEL NO. PG.19 BILEX730 ! WARNING! CABINET FRAME, CABINET AND COUNTER TOP MUST BE MADE FROM NON-COMBUSTIBLE MATERIAL. ! ! DANGER IF YOU SMELL GAS: • Shut off gas to the appliance. • Extinguish any open flame. • Open lid.
Napoleon President’s 15 Year Limited Warranty NAPOLEON products are designed with superior components and materials, and are assembled by trained craftsmen who take great pride in their work. The burner and valve assembly are leak tested and test-fired at a quality test station. This grill has been thoroughly inspected by a qualified technician before packaging and shipping to ensure that you, the customer, receive the quality product you expect from NAPOLEON.
! WARNING! Failure to follow these instructions could result in property damage, personal injury or death. Read and follow all warnings and instructions in this manual prior to operating grill. Safe Operating Practices • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • N415-0564-AU Jun 17.20 This gas grill must be assembled exactly according to the instructions in the manual.
Location Locating Your Outdoor Gas Grill It is important when selecting a location for your gas grill to ensure clearances to adjacent combustibles are met. This appliance is intended for installation on an outdoor patio or in your yard. ‘This appliance shall only be used in an above ground open-air situation with natural ventilation, without stagnant areas, where gas leakage and products of combustion are rapidly dispersed by wind and natural convection.
General Information This gas grill is certified for outdoor use and should be installed to conform to local codes. Check gas type and specifications located on the rating plate of the grill. ! Universal Liquefied Petroleum Gas Cylinder Specifications WARNING! If these instructions are not followed exactly, a fire causing death or serious injury may occur.
BUILT IN UNIVERSAL LIQUEFIED PETROLEUM GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and piping should be located as shown in the built-in instructions. A flexible metal connector is included to simplify the installation of the unit. Connect this flexible metal connector to the flare fitting with 3/8” SAE 45O Flare Inlet Connection (5/8-18 UNF thread) on the end of the manifold. Connect the other end of the connector to the supplied bottle regulator.
BUILT IN NATURAL GAS HOOK-UP: The piping up to the gas grill is the responsibility of the installer and piping should be located as shown in the built-in instructions. A flexible metal connector is included to simplify the installation of the unit. Connect this flexible metal connector to the flare fitting (3/8” SAE 45O Flare Connection 5/8-18 UNF thread) Connect the other end of the connector to the supplied gas regulator.
! ! Leak Testing Instructions WARNING! A leak test must be performed annually and each time a cylinder is hooked up or if a part of the gas system is replaced. WARNING! Never use an open flame to check for gas leaks. Be certain no sparks or open flames are in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, damage to property, serious bodily injury, or death.
Lighting Instructions Lights ! ! Left Burner Rear Left Centre Centre Right Centre Infra Red Burner Burner Burner Burner Burner Off Position WARNING! Open lid. WARNING! Ensure all burner controls are in the off position. Turn on the gas supply valve. Main Burner Lighting Rear Burner Lighting (Rotisserie Burner) (if equipped) Side Burner Lighting (If equipped) 1. Open grill lid. 1. Open grill lid. 1. Open side burner cover. 2. Push and turn any main burner knob slowly to the ’hi’ position.
Cooking Instructions Initial Lighting: When lit for the first time, the gas grill emits a slight odor. This is a normal temporary condition caused by the “burn-in” of internal paints and lubricants used in the manufacturing process and does not occur again. Simply run the main burners on high for approximately one-half hour. Main Burner Use: When searing foods, the lid must be kept open and the burners can be set to high.
Infrared Heat 11 Most people don’t realize that the heat source we are most familiar with, our sun, warms the earth using mainly infrared energy. This is a form of electro-magnetic energy with a wavelength just greater than the red end of the visible light spectrum but less than a radio wave. This energy was discovered in 1800 by Sir William Herschel who dispersed sunlight into its component colors using a prism.
Infrared Grilling Chart Food Control Setting Cooking Time Helpful Suggestions Steak 1 in. (2.54cm) thick High setting 2 min. each side. 4 min. – Rare High setting 2 min. each side then medium setting. 6 min. – Medium High setting 2 min. each side then medium setting. 8 min. – Well done When selecting meat for grilling, ask for marbled fat distribution. The fat acts as a natural tenderizer while cooking and keeps it moist and juicy. High setting 2 min. each side. 4 min.
Cleaning Instructions WARNING! Always wear protective gloves and safety glasses when servicing your grill. ! ! WARNING! To avoid the possibility of burns, maintenance should be done only when the grill is cool. Avoid unprotected contact with hot surfaces. Ensure all burners are turned off. Clean grill in an area where cleaning solutions will not harm decks, lawns, or patios. Do not use oven cleaner to clean any part of this gas grill.
Maintenance Instructions We recommend this gas grill be thoroughly inspected and serviced annually by a qualified service person. At all times keep the gas grill area free from combustible materials, gasoline and other flammable vapors and liquids. Do not obstruct the flow of ventilation and combustion air. Keep the cylinder enclosure ventilation openings (located on the cart sides and at the front and back of the bottom shelf) free and clear from debris.
clean if the burner is removed from the grill, but it can also be done with the burner installed. Do not flex the drill bit when drilling the ports, as this will cause the drill bit to break. This drill is for burner ports only, not for the brass orifices (jets) which regulate the flow into the burner. Take care not to enlarge the holes. Ensure the insect screen is clean, tight, and free of any lint or other debris. Reinstallation: Reverse the procedure to reinstall the burner.
Troubleshooting Problem Possible Causes Solution Low heat / Low flame when valve turned to high. For Universal Liquefied Petroleum Gas - improper lighting procedure. Ensure lighting procedure is followed carefully. All gas grill valves must be in the off position when the tank valve is turned on. Turn tank on slowly to allow pressure to equalize. See lighting instructions. For natural gas - undersized supply line. Pipe must be sized according to installation code.
Problem Possible Causes Solution Humming regulator. Normal occurrence on hot days. This is not a defect. It is caused by internal vibrations in the regulator and does not affect the performance or safety of the gas grill. Humming regulators will not be replaced. Burners will not cross light each other. Dirty or corroded cross light brackets. Clean or replace as required. “Paint” appears to be peeling inside lid or hood. Grease build-up on inside surfaces. This is not a defect.
KEEP YOUR RECEIPT AS PROOF OF PURCHASE TO VALIDATE YOUR WARRANTY. Ordering Replacement Parts Warranty Information MODEL: DATE OF PURCHASE: SERIAL NUMBER: (Record information here for easy reference) For replacement parts and warranty claims, contact the Napoleon dealer where the product was purchased. Before contacting the dealer, check the Napoleon Grills Website for more extensive cleaning, maintenance, troubleshooting and parts replacement instructions at www.napoleon.com.
CAUTION! During unpacking and assembly we recommended you wear work gloves and safety glasses for your protection. Although we make every effort to make the assembly process as problem free and safe as possible, it is characteristic of fabricated steel parts that the edges and corners might be sharp and could cause cuts if handled incorrectly. Getting Started 1. Remove all cart panels, hardware, and grill head from carton. Raise lid and remove any components packed inside.
BUILT-IN UNIT OPENING DIMENSIONS MODEL OPENING DIMENSIONS NOTES W D H BILEX730 43 1/4” 1099mm 21 3/8” 543mm 8 7/8” 225mm SIDE BURNER 12 3/4” 324mm 16 1/2” 419mm 4 1/2” 114mm ! OPENING OF AT LEAST 5 SQ (32cm2) IN MUST BE PROVIDED FOR COMBUSTION AIR FOR SIDE BURNER. WARNING! This grill is designed for Non-combustible enclosures only, and must be installed and serviced by a qualified installer to local codes.
BILEX730 BUILT-IN INSTRUCTIONS 6 x N570-0073 (1/4-20 X 3/8”) 3/8”(10mm) This grill is designed for masonry, NON-COMBUSTIBLE enclosures only and must be installed and serviced by a qualified installer to local codes. 1. Attach side mounting brackets to each side of the grill using #1/4-20 x 3/8” screws (N570-0073). 2. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be applied to each wing of the rear trim. 3.
FOLD TABS OVER TO SECURE GLASS IN PLACE. www.napoleon.com N415-0564-AU Jun 17.
Rotisserie Kit Assembly Instruction (optional) Assemble rotisserie kit components as shown. Ensure stop bushing is tightened on the inside of hood casting. N415-0564-AU Jun 17.20 www.napoleon.
Leak Testing Instructions ! ! WARNING! A leak test must be performed annually and each time a cylinder is hooked up or if a part of the gas system is replaced. WARNING! Never use an open flame to check for gas leaks. Be certain no sparks or open flames are in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, damage to property, serious bodily injury, or death.
Parts List Item 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 Part # N135-0042-GY1HT N135-0043-GY1HT N335-0045L-M02 N585-0082 N570-0091 N010-0741 N385-0307-SER N450-0044 N510-0013 N080-0287-GY1HT N570-0019 N570-0015 N735-0003 N570-0073 N010-0833 N570-0008 N685-0013 N010-0546-AU N010-0547-AU N200-0080-M02 N010-0281 N255-0027 W445-0031 N570-0078 N100-0036 N080-0209 N010-0599-M01 Z510-0003 N200-0082-GY1SG N475-0322-AU N105-0001 N750-0022B N660-000
Item 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 Parts List Part # N305-0058 N520-0025 N475-0301-M02 N010-1209-AU N585-0134 N715-0086-M02 N080-0216-M02 N010-0499 N300-0006 N080-0309 N080-0207-M01 N215-0007-M01 N010-0527P-AU N010-0527N-AU N455-0077 N455-0078 N720-0053 N240-0030 N160-0017 N200-0114 Z570-0002 N615-0011 N455-0079 N455-0080 N720-0073 N530-0048 N530-0047 Z570-0035 N570-0073 N710-0062 N020-0126 69334 61731 56018 56040 67732 62007 www.napoleon.
1 5 3 17 4 5 2 7 14 13 19 12 5 10 62 8 5 11 5 16 34 36 35 59 9 10 16 27 15 60 5 9 6 52 62 39 54 56 51 62 16 12 16 40 39 16 22 22 33 38 38 39 16 63 31 33 28 34 47 26 16 20 18 23 14 16 24 23 14 16 24 23 30 48 63 41 46 45 49 16 63 50 48 26 25 43 53 21 45 29 61 42 64 N415-0564-AU Jun 17.20 32 55 16 37 14 44 www.napoleon.
Napoleon products are protected by one or more U.S. and Canadian and/or foreign patents or patents pending. www.napoleon.
