User Manual
3
www.napoleon.com
N415-0563-AU JUL 16.19
WARNING! Failure to follow these instrucons could result in property damage, personal injury
or death. Read and follow all warnings and instrucons in this manual prior to operang grill.
Safe Operang Pracces
• This gas grill must be assembled exactly according to the instrucons in the manual. If the grill was store
assembled, you must review the assembly instrucons to conrm correct assembly and perform the
required leak tests before operang the grill.
• Read the enre instrucon manual before operang the gas grill.
• This gas grill must be used only outdoors in a well-venlated space and must not be used inside a building,
garage, screened-in porch, gazebo or any other enclosed area.
• This gas grill must not be installed in or on recreaonal vehicles and/or boats.
• Do not locate unit in windy sengs. High winds adversely aect the cooking performance of the gas grill.
• Do not modify this appliance.
• Do not operate unit under overhead combusble construcon.
•
The non-combusble installaon must be located to maintain proper clearance to any adjacent combusble
construcon, such as combusble exterior walls of residenal buildings (27” (686mm) to rear of unit, 24”
(610mm) to sides). Addional clearance of 24” (610mm) is recommended near vinyl siding or panes of glass.
• Gas must be turned o at the gas supply valve when the gas grill is not in use.
•
If the enclosure is to house a Universal Liqueed Petroleum Gas cylinder, the tank poron of the enclosure
must be venlated according to local codes, and must not have communicaon with the cavity used to
enclose the gas grill. A Universal Liqueed Petroleum Gas cylinder tank cannot be stored below the gas grill.
• When the Universal Liqueed Petroleum Gas cylinder is connected to the appliance, the gas grill and
cylinder must be stored outdoors in a well-venlated space.
• Inspect the fuel supply hose before each use. If there is evidence of excessive abrasion or wear or the hose
is cut, it must be replaced prior to using the gas grill with a replacement hose assembly specied by the
grill manufacturer.
• Periodically check the test date on the ULPG gas cylinder to ensure it is within its service life specicaon.
If required, contact an approved tesng facility or ULPG supplier for re-cercaon or replacement.
• Leak test the unit before inial use, annually, and whenever any gas components are replaced.
• Follow lighng instrucons carefully when operang grill.
• Burner controls must be o when turning supply cylinder valve on.
• The lid is to be closed during the gas grill preheang period on all models except the BISZ300NFT/PFT and
the built-in side burner BISB245.
• The BISZ300NFT/PFT and the built-in side burner BISB245 are supplied with a at cover for storage and
protecon from the elements. Never place this cover on the grill while hot or operang. Allow grill to cool
completely before covering.
• Adults and especially children should be alerted to the hazards of high surface temperatures. Young
children should be supervised near the gas grill.
• Do not place arcles on or against this appliance.
• Do not leave grill unaended when operang.
• Do not light burners with lid closed.
• Do not use or store ammable materials in or near this appliance.
• Do not operate rear burner with main burners operang.
• Do not move grill when hot or operang.
• Keep any electrical supply cord and fuel supply hose away from any heated surfaces.
• Do not spray aerosols in the vicinity of this appliance while it is in operaon.
• Ensure sear plates are posioned properly according to sear plate installaon instrucons. The holes must
be towards the front of the gas grill (if applicable).
• Clean grease tray and sear plates regularly to avoid build-up, which could lead to grease res.
•
Remove warming rack before lighng rear burner. The extreme heat will damage the warming rack.
• Inspect infrared burner venturi tube for spider webs and other obstrucons periodically. Clean the tubes
completely if you nd any such obstrucons.
• Do not allow cold water (rain, sprinkler, hose, etc.) to come in contact with heated unit. A large
temperature dierenal can cause chipping in the porcelain.
• Do not allow cold water (rain, sprinkler, hose, etc.) to come in contact with ceramic burners. A large
temperature dierenal can cause cracking in the ceramic le.
• Do not use a pressure washer to clean any part of the unit.
!