User Manual

20
www.napoleon.com
N415-0563-AU JUL 16.19
BILEX605 BUILT-IN INSTRUCTIONS
3/8”(10mm)
Install baeries as illustrated. Plug wire from LED (lights) located underneath
control panel into wire from baery pack. Ensure wires do not come in contact
with the boom of the grill. The baery pack module must be mounted inside
the enclosure, at least 8 inches (20cm) below the boom of the drip pan, to
prevent the module from overheang. Ensure wires and module do not interfere
with drip pan removal.
!
This grill is designed for masonry, NON-COMBUSTIBLE enclosures only and must be installed and serviced
by a qualied installer to local codes.
1. Aach side mounng brackets to each side of the grill using #1/4-20 x 3/8” screws (N570-0073).
2. Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be
applied to each wing of the rear trim.
3. Lower the unit in place, the wings on the rear trim should be under the side mounng brackets.
Connect the ex supply line to the ng at the end of the manifold.
4. The enre installaon must be leak tested before operang the unit.
1
2
3
3
1
1
2
3
4
Drip Pan
Heat Shield
x6
N570-0073 (1/4-20 X 3/8”)