User Manual
14
www.napoleon.com
N415-0562-AU JUN 17.20
to clean them. Drill out blocked ports using this drill bit in a small cordless drill. The ports are easier to
the drill bit when drilling the ports, as this will cause the drill bit to break. This drill is for burner ports only,
Reinstallaon: Reverse the procedure to reinstall the burner. Check that the valve enters the burner when
installing.
WARNING! Regulator Hose (when applicable): Check for abrasions’, melng, cuts, and cracks
in the hose. If any of these condions exist, do not use the gas grill. Have the part replaced by your
Napoleon Gas Grill dealer or qualied gas installer.
WARNING! When reinstalling the burner aer cleaning it is very
important that the valve/orice enters the burner tube before lighng your
gas grill. If the valve is not inside the burner tube a re or explosion could
occur.
Aluminum Casngs
surface to
Infrared Burners
Protecon Of Infrared Burners: The infrared burners of your grill are designed to provide a long service
life, though care must taken to prevent cracking of their ceramic surfaces. Fractures will cause the burners
them. Damage caused by failure to follow these steps is not covered by your grill warranty.
removing cooking grates and accessories into or from the grill.
pressure to crack the ceramic. Repeated soaking of the ceramic can also cause it to swell and expand. This
expansion causes undue pressure on the ceramic that can cause it to crack and crumble.
the burner from the grill. Turn it upside down to drain the excess water and bring indoors to dry
thoroughly.
!
!