Installation Guide

W415-1696 / 10.12.16
32
EN
A. Remove the top front and top rear panels. Refer to section 5.11 (Step B).
B. Unplug the wires connected to the heater and blower. NOTE: Use pliers to pinch the connector
free from the heater tabs for easier removal.
C. Remove the 6 screws that secure the heater and blower assembly to the appliance (Figure 1).
D. Take the blower and heater assembly out of the appliance.
E. Remove the 6 screws that secure the blower to the bracket (Figure 2).
F. Remove the 3 screws located on the sides of the heater housing then remove the heater by sliding it
up and out of the housing (Figure 3).
G. Remove the wires by removing the single screw from the back of the heater housing, then bend the
two tabs upwards that secure the wires in place (Figure 4).
5.12 HIGH LIMIT SWITCH, HEATER, AND BLOWER REPLACEMENT
FIG. 1
FIG. 2
FIG. 3
FIG. 4
INSTRUCTIONAL VIDEO:
HOW TO REPLACE HIGH LIMIT SWITCH, HEATER, AND BLOWER