Installation Guide

W415-1696 / 10.12.16

Once the appliance has been plugged into a grounded electrical outlet or hardwired to a grounded 120V

power supply, it is ready to operate.

NOTE: Ensure the house circuit breakers for the power supply are turned on. In the event of a power

failure, when the main power switch of the appliance is in the "I" ON position and the hand held remote

control is in the ON position, the ﬂ ame generation lights will come back on at the high setting, when

the power supply returns.

The main power switch and control panel are located on the top front of the appliance as illustrated.

POWER SWITCH

HEATER

FLAME

INDICATOR

A. Turn main power switch ON, the ﬂ ame will be at the brightest setting and the heater will be OFF. To

turn on the heater, push the heater button .

B. To adjust the ﬂ ame brightness, press the ﬂ ame button . There are three brightness levels to cycle

through and then an off setting (F1, F2, F3 and then F0). Every time the ﬂ ame is initiated it will start

at the brightest level.

C. The default setting temperature display is Fahrenheit. To change to the desired temperature format,

press and hold the ﬂ ame button for 5 seconds, this will change the display from Fahrenheit to

Celsius, or vice versa.

NOTE: After the heater button is pushed, there will be an 8 second delay

between the blower turning on and the heater turning on. After turning

off the heater, the blower will be on for 8 seconds to blow out remaining

heat.

1.0 OPERATING INSTRUCTIONS

1.1 MAIN POWER SWITCH AND CONTROL PANEL

INSTRUCTIONAL VIDEO:

OPERATING INSTRUCTIONS