Installation Guide

W415-1696 / 10.12.16

5.7 LED REPLACEMENT

A. Find the connector on the PCB for the LED you want to replace and unplug it (Section 5.8 Figure 1).

B. Cut the cable tie.

C. Unscrew the LED strip from the appliance. If unscrewing the log LEDs, use a pair of needle nose

pliers to hold the plastic plugs in place.

D. Screw in the new LED strip onto the appliance and connect the wires to the designated quick connect

plugs.

E. Using a cable tie, secure the wires.

A. To gain access to the remote receiver or thermostat, see sections 5.0 - 5.4 and 5.11 (Step B).

B. Find the connector on the PCB for the component you want to replace and uplug it (Figure 1).

C. Cut the cable tie.

D. Unscrew the component from the appliance.

E. Screw the new component and connect the wires to the designated quick connect plugs.

F. Using a cable tie, secure the wires.

THERMOSTAT

REMOTE RECEIVER

CONTROL PANEL

DECORATIVE LED

FLAME LED EMBER BED / LOG LED

FIG. 1

5.8 REMOTE RECEIVER / THERMOSTAT REPLACEMENT