Installation Guide

W415-1696 / 10.12.16
28
EN
5.5 MOTOR REPLACEMENT
A. To gain access to the motor, see sections 5.0 - 5.4.
B. To remove the refl ector, pull the refl ector away from the
motor for it to release.
C. Remove the rubber adaptor from the motor.
D. Unplug the quick connect motor wire from the wire
harness.
E. Unscrew the 2 screws holding the motor and take the
motor out of the appliance.
F. Install the new motor.
G. Reinstall the screws, rubber adaptor, and refl ector.
5.6 CONTROL BOARD REPLACEMENT
A. To gain access to the PCB, see sections 5.0 - 5.4.
B. Unplug all the wires connected to the control board.
NOTE: For ease of wire disconnection, use a pair of
needle-nose pliers.
C. Remove control board from appliance.
NOTE: To prevent stripping of the plastic plugs on the
back of the control board, hold the plugs with pliers
while removing each of the 4 screws.
D. Screw the new board into the plugs in the same orientation
as before.
E. Connect all of the wires to the board. See 5.8 fi gure 1 for
reference.
ADAPTOR
REFLECTOR
MOTOR
INSTRUCTIONAL VIDEO:
HOW TO REPLACE MOTOR
INSTRUCTIONAL VIDEO:
HOW TO REPLACE CONTROL BOARD