Installation Guide

W415-1696 / 10.12.16
25
EN
5.0 MAINTENANCE
!
WARNING
ALWAYS DISCONNECT THE POWER AND ALLOW THE ELECTRIC APPLIANCE TO COOL BEFORE
PERFORMING ANY CLEANING, MAINTENANCE, OR RELOCATION OF THIS ELECTRIC APPLIANCE.
TURN CONTROLS TO OFF AND REMOVE PLUG FROM OUTLET OR TURN OFF THE HOUSE
CIRCUIT BREAKER TO ELECTRIC APPLIANCE RECEPTACLE.
DO NOT INSTALL REPLACEMENT LED LIGHTS THAT EXCEED SPECIFIED MAXIMUM WATTS.
NOTE: Only a qualifi ed service technician or service agency should service this electric
appliance.
!
5.1 GLASS DOOR REMOVAL AND INSTALLATION
!
WARNING
THE DOOR LATCHES ARE PART OF A SAFETY SYSTEM AND MUST BE PROPERLY ENGAGED. DO
NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRE OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
75.1
A. To remove the glass door, swing the top two latches to release the door. The door will hang slightly
on the safety catch wire. NOTE: Pushing in the door, will make the latch swing easier.
B. Place one hand on the glass door while removing the screw from the catch wire. Allow the door to
pivot slightly, hold the sides with both hands while lifting the door out of the appliance.
C. To install the glass door, simply place the door on the holding pins on the bottom frame of the
appliance. Install the screw into the safety catch wire, slightly push the glass door into the frame
and latch it secure with the two top latches.
SAFETY
CATCH WIRE
SCREW
LATCH
* ILLUSTRATED WITH LATCHES VISIBLE
LOCK
OPEN