Installation Guide

ManualsBrandsNAPOLEON ManualsElectric Fireplace Inserts40 in. Built-In Electric Fireplace Insert

W415-1696 / 10.12.16

Unplug the appliance

(if hardwired, turn off circuit breaker)

To gain access to the PCB, wire

harness, and decorative LED, refer to

sections 5.0 - 5.4 and 5.11 (Step B)

Ensure the wires from decorative LED (CN5)

are not pinched, frayed, and are ﬁ rmly

connected on the PCB and decorative LED

(Figure 22)

Plug in the appliance

(if hardwired, turn on circuit breaker)

Set the appliance to d2 setting by

pressing the decorative light button

on the remote control

Wait 60 seconds and

observe the d2 colour cycle

(Decorative Light Settings)

Are all colours working?

(blue, white, and yellow)

Unplug the

connector from CN5

Turn appliance on

(control panel switch)

Set multimeter to read DC voltage

and appliance to the d2 setting

Place the positive probe on the CN5

COMM connector pin (Figure 23)

Place the negative probe on the the

CN5 W connector pin (Figure 24)

Place the negative probe on the the

CN5 R connector pin (Figure 25)

Place the negative probe on the the

CN5 B connector pin (Figure 26)

Wait 60 seconds

Replace the PCB.

Refer to section 5.6 (Control Board

Replacement)

Appliance is functioning

accordingly. Refer to section

5.0 - 5.4 for part reinstallation

Turn appliance off

(control panel switch)

Replace the

decorative LED strip.

Refer to section 5.7

(LED replacement)

Is the voltage reading 12V

DC for each connector

pins?

YES

DECORATIVE LIGHT SETTINGS

There are three settings to cycle through and an off setting (d1, d2, d3 and

then d0). The d1 setting turns the light to white. The d2 setting cycles the

decorative LED in the following order:

- White to orange

- Orange to blue

- Blue to orange & blue

- Orange & blue to orange & white

- Orange & white to white & blue

It will take 8.5 seconds to switch from one colour to the next when in d2

setting. The d3 setting will lock to a desired colour from the d2 setting.

WARNING

DO NOT LET PROBES TOUCH WHILE TESTING CN5 TERMINAL ON THE PCB.

THIS WILL SHORT THE ENTIRE APPLIANCE.

4.4 DECORATIVE LED TESTING

START HERE