Installation Guide

W415-1696 / 10.12.16
14
EN
4.1.2 MOTOR TESTING
NO
NO
YES
YES
Replace the wire harness
Replace the motor.
Refer to section 5.5
(Motor Replacement)
Replace the PCB.
Refer to section 5.6
(Control Board Replacement)
Unplug the appliance
(If hardwired, turn off circuit breaker)
Plug in the appliance
(If hardwired, turn on circuit breaker)
Set multimeter to read
AC voltage
Place positive probe on the
MOTOR terminal (Figure 2)
Disconnect the wire on the
MOTOR terminal on the PCB
Reconnect the wire into the
MOTOR terminal on the PCB
Place negative probe on the ground screw on
the junction box located in the bottom right
corner of the appliance (Figure 4)
Is there a voltage reading
approximately 120V AC?
Follow the wire from the motor
until you reach the clear plastic
connectors and disconnect them
(Figure 5)
Using the connector from the PCB/wire
harness, place positive probe into the
terminal with the brown wire and the
negative probe into the terminal with the
white wire (Figure 6)
Is the voltage reading
approximately 120V AC?
START HERE