Use and Care Guide

EN
W415-1299 / B / 06.16.14
18
If the log's LED lights become damaged replace with the proper LED light.
A. Place a hand on the glass to hold it in place while removing the 10 screws on the bottom of the
glass. The glass will fall down to 2 holding tabs.
B. Tilt the glass forward on the bottom with both hands, lift the glass up and out of the unit.
C. Place the glass on a soft, non-abrasive surface.
6.2 LOG AND LOG LED REPLACEMENT
6.3 FLAME GLASS REMOVAL
A. Remove the 5 screws on the bottom and 4 screws
on top of the fl ame board.
B. Lift the fl ame board out of the unit.
6.4 FLAME BOARD REMOVAL