User's Manual

4
IBR-ZREMOTE
CUSTOMER ROUTER
(Wireless or Wired-only)
WIRING OVERVIEW with IBR-ZREMOTE and ISEE-WAP
KEYPAD BUS
BROADBAND
MODEM
NETWORK
CONTROL
PANEL
STANDARD
KEYPAD
Internet
RED
BLACK
GREEN
YELLOW
GREEN
YELLOW
TO PANEL SERIAL PORT (only
needed for IBR-ZREMOTE CS
communication or panel
downloading)
RED
BLACK
ISEE-WAP
IBR-ITAB-HW
CAMERAS
(((
(((
IBR-ITAB
(
(
(
(((
NETWORK
(
(
(
(
(
(
Remote Services
(
(
(
Z-WAVE DEVICES
Installing the IBR-ZREMOTE Z-Wave
®
Controller, ISEE-WAP Wireless
Access Point and the IBR-ITAB Wireless Touchscreen Tablet
The iBridge Suite allows consumers to control their alarm system, Z-Wave devices and video cameras from wireless
and wired Touch Screens, Android and Apple devices and from a PC web browser independently or all at the same time
from inside the premises or out.
This guide will walk you through the steps required to set up a typical system. The key components are:
• IBR-ZREMOTE: This the "hub" of the system. It links the Napco alarm control panel keypad bus, a Wi-Fi access
point, and an internal Z-Wave controller allowing commands to flow from one system to another via an
interconnected TCP/IP network within the premises or over the Internet. The IBR-ZREMOTE also has an integral NL-
MOD to allow the reporting of alarms to a Napco NetLink Receiver and to remotely configure the alarm control panel
over the Internet. Because the IBR-ZREMOTE is connected to the Napco keypad bus, it must be programmed with a
unique keypad address number. It is shipped defaulted as KEYPAD ADDRESS number 1, but is easy to change.
• ISEE-WAP: This is the Wi-Fi access point that allows wireless devices (cameras, Touch Screens, etc.) to gain
access to the IBR-ZREMOTE and the TCP/IP network. (Not required if not using cameras or IBR-ITAB wireless
Touch Screen).
• IBR-ITAB: This is a completely wireless Touch Screen that connects to the ISEE-WAP using built in Wi-Fi for control
of Security, Z-Wave and Video. The IBR-ITAB-HW is a slight variation of the IBR-ITAB and differs in the
management of the security connection. In this case the IBR-ITAB-HW is wired directly to the Napco control panel
keypad bus to control security and the integral Wi-Fi is used only for Video and Z-Wave control.
The overall system layout is shown below: